EAA technical counselor and A&P/IA Dick Koehler demonstrates the use of heat shrinkable solder sleeves and how they can conveniently be used to tie ground wires together.
Crimping Butt Connectors
EAA technical counselor and A&P/IA Dick Koehler discusses how to use butt connectors and demonstrates wire splicing using a butt connector.
Basics of Stripping and Crimping Wire
Dick Koehler demonstrates basic techniques of stripping and crimping wire. Dick is a technical counselor for EAA Chapter 186, an A&P mechanic with IA, and a SportAir Workshop instructor.
Key Switch Installation
Tracy Buttles from the EAA staff demonstrates how to install a ignition key switch into an instrument panel in a way that locks it in place and prevents it from rotating within the mounting hole.
Voltage Regulator Overview
EAA Technical Counselor and A&P/IA mechanic Dick Koehler shows the inside of a mechanical voltage regulator and discusses the component parts and how it all works to regulate voltage in an aircraft's electrical system.
Antenna Ground Plane
Antenna ground planes for composite or wood aircraft can be made in various ways. EAA Technical Counselor and A&P/IA mechanic Dick Koehler demonstrates how to use copper foil tape to make a light weight and effective antenna ground plane.
Labeling Electrical Wires
Labeling electrical wires is sometimes overlooked during the building process. EAA volunteer Fred Stadler shows how effective a label maker can be to mark heat shrink tubing and install on wires as a method to mark wires for later identification.
Molex Avionics Connectors
Dick Koehler demonstrates how to make a Molex connector commonly used in avionics installations. Dick is a Technical Counselor for EAA Chapter 186, A&P aircraft mechanic with Inspection Authorization (IA), and SportAir Workshop instructor.
Dick Koehler discusses types of electrical switches and their usage. Dick is a Technical Counselor for EAA Chapter 186, A&P aircraft mechanic with Inspection Authorization (IA), and SportAir Workshop instructor.
Electrical Volt-Ohm Multimeter
Dick Koehler discusses the use of a digital volt/ohm multimeter which is a useful tool for diagnosing electrical issues.
Soldering Tips-Holding Wires
Holding 2 wires together for soldering can be a challenge, especially if they are under your instrument panel. Mitch Zehr from the EAA aircraft maintenance staff shows how to use the plastic top from a spray can to help make it easier.
Solenoids: Master Relay and Starter Relay
Most aircaft are going to have a master relay and a starter relay. Dick Koehler discusses operation and installation of the relays. Dick is a technical counselor for EAA Chapter 186, an A&P mechanic with IA, and a SportAir Workshop instructor.
- Load More