Webinar- 3-D Scanning and SOLIDWORKS Modeling
Stefan Hokuf from Aeroscan discusses how 3-D scanning is being used in aircraft repair and restoration; including the reverse engineering process from 3-D scan to post-production to model creation in SOLIDWORKS to sourcing fabrication.
Webinar- Operating Oversquare
Many pilots of constant speed prop airplanes have been cautioned never to operate oversquare, with manifold pressure (in inches) above rpm (divided by 100), to avoid damaging the engine. This is dead wrong according to engine guru Mike Busch.
Webinar- Post-Maintenance Checklist
The first flight after maintenance is by far the most likely time for something to go wrong with the aircraft. Mike Busch A&P/IA offers advice on what you should do before and during the first flight after an annual or other major maintenance.
Webinar- Flying to the Bahamas
If flying to a beautiful destination is on your bucket list, this presentation is for you. Bahamas Flying Ambassador Mike Zidziunas answers common questions about the requirements, and discusses the risks and rewards of flying to the Bahamas.
TCC Webinar - The North American Trainer Association
In the Q4 TCC webinar, the North American Trainer Association’s Larry Lumpkin and Bruce Mayes cove their type club business and membership practices, safety programs and other key efficacy items making them one of the strongest clubs today.
Webinar- Charting Your Course- Deciphering the VFR Sectional Chart
CFI Prof. H. Paul Shuch will walk you through the VFR sectional aeronautical charts most frequently encountered symbols, and teach you how to interpret the chart’s sometimes confusing key.
Webinar- How to Prepare for an Unknown Aerobatic Sequence
Jim Bourke from the IAC will discuss the preparation needed for a pilot to adjust their practice in order to fly a sequence that they have never flown before.