Drilling Holes in Composites
EAA Technical Counselor Mike Busch demonstrates the use of a hole saw to cut accurate holes in cured composite materials.
Repairing Broken Foam Sheet
EAA Technical Counselor Mike Busch demonstrates how to repair broken sheets of polyurethane foam.
Squaring Up Blue Foam
EAA Technical Counselor Mike Busch demonstrates how to use a hot-wire bow to square up large billets of blue styrofoam.
Epoxy Resin Scratch Test
EAA Technical Counselor Mike Busch demonstrates a tip to test epoxy resin to verify it has cured properly.
Hot-Wire Cutter Components
Using a hot-wire is an effective way to cut foam block used for composite construction. EAA staff member Mark Forss shows the component part that make up a hot-wire bow system.
Locating Blind Holes
EAA Technical Counselor Mike Busch provides a tip to help locate holes without the use of a hole-finder tool.
Composite Post-Cure Quality Checks
EAA Technical Counselor Mike Busch shows ways to inspect cured composite layups to inspect for any defects in the finished part.